ZBoost YX600 Series Installation Guide download pdf (Page 12)

Wi-Ex

YX600 Series Installation Guide

Power Requirements

The Base Unit can be plugged into a standard 2-prong 110 VAC receptacle

using the included power supply. The power supply consumes less than 10W

(less than 0.2A).

Warning:

The zBoost YX600 Series base unit MUST

only be used with the provided power adaptor.

Use of other power adaptors will void the

warranty and may damage the unit. Use of

other equipment is not FCC approved.

Installation Tools Needed

The following tools are needed to install zBoost:

• #2 Philips screwdriver

• Cellular phone operating in the band supported by your zBoost unit

• Drill (may be required for outdoor or attic antenna installations)

Installing Your zBoost

Installing the Signal Antenna

Choosing the best location for installation of the Signal Antenna provides the

best performance and the largest area of improved signal. Determine the

location which provides the strongest signal using the signal strength indicator

on your cell phone. Find the location which provides the most bars of signal

strength and locate the Signal Antenna at that location. This location will be

typically found on the roof.

Warning:

Avoid placing antenna near metal such as

wiring, A/C ducts, truss plates, etc.

When attaching the cable to the antenna, run

the cable straight down from the antenna.

Avoid draping the coax near the antenna.

Figure 3 Figure 4

YX023-PCS Antenna YX021-CEL Antenna

for YX600-PCS for YX600-CEL

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

No comments

ZBoost YX600 Series Installation Guide Page 12