ZBoost Xtreme REACH User Manual download pdf (Page 13)

zBoost

Xtreme REACH ZB560SL Manual

NOTE: The zBoost Xtreme REACH ZB560SL requires at least 15 feet of vertical separation

between the Base Unit and the External Antenna. Generally, increasing this distance (up to 40 feet)

will increase the performance and decreasing the distance will limit zBoost performance. Keep the

Base Unit off the oor and at least 2 feet away from other cords, metal objects or other wireless

devices such as wireless routers or wireless access points. The zBoost performs best when there

are no obstructions between the zBoost Base Unit and your mobile device.

Upon initial power up, the LED will cycle RED, GREEN and ORANGE for 30 seconds. After 30

seconds, a series of GREEN ashes will indicate the quality of your setup. Following this, a solid

GREEN light indicates normal conditions. If it is not solid GREEN, follow the instructions in the

Base Unit LED Indicators section. Adjustments may be needed to optimize performance. If you nd

the increased signal coverage is acceptable, however, no additional adjustments are needed. See

“Base Unit Light Indicators” on page 11) for more information.

SECOND: Position Base and Indoor

Antenna

Connect the Indoor Antenna to the Base Unit and

place it where you need signal. For the widest possible

signal area, position the Base Unit near the middle

of a room. You may also mount it on an interior wall

by rst removing the bracket, screwing the bracket

to a wall (screws not included), then snapping the

Base Unit back in place keeping the Indoor Antenna

vertical. The Base Unit uses an omni-directional

Indoor Antenna that delivers signal in a circular pattern

around the antenna.

The zBoost Xtreme REACH requires at least 15 feet

of vertical separation between the Base Unit and the

External Antenna. Generally, increasing this distance

(up to 40 feet) will increase the performance and

decreasing the distance will limit the performance.

Keep the Base Unit off the oor and at least 2 feet away from other cords, metal objects or other

wireless devices such as wireless routers or wireless access points. The zBoost Xtreme REACH

performs best when there are no obstructions between the zBoost Base Unit and your mobile

device.

Wall Mounting the Base Unit

The Base Unit can also be easily mounted on a wall. The Base Unit should be a minimum distance

of 4-5 feet off from the oor so there is clearance for the Indoor Antenna extension.

Perform the following steps to mount the Base Unit on a wall:

1. Remove the mounting bracket from the Base Unit by slightly spreading the tabs on the

Note

Avoid placing the External Antenna near metal such as

wiring, A/C ducts, metal siding, truss plates, etc.

When connecting the cable to the antenna, run the cable

straight down from the antenna. Avoid draping the coax

near the antenna.

zBoost Base Unit

Power Supply

Base Unit Antenna

Coaxial Cable

Base Unit Bracket

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments

ZBoost Xtreme REACH User Manual Page 13

Comments to this Manuals

Related products and manuals for Cellular signal boosters ZBoost Xtreme REACH