ZBoost YX600 Series User Manual download pdf

~·»E

Extending

Cell

Zones

YX039-PCS-CEL

Dual-Band

Signal Antenna

Installation Guide

The YX039-PCS-CEL dual-band outdoor signal antenna system allows your Wi-Ex cell phone signal

booster to provide a larger area of improved indoor signal strength and improve indoor performance

where weak outdoor cell signals exist. The antenna operates with signals

both the 850 MHz Cellular

and the 1900 MHz PCS bands.

The YX039-PCS-CEL dual-band antenna system consists of two directional panel antennas, one for the

Cellular band (850 MHz) and one for the PCS band (1900 MHz). An antenna combiner

included to

combine the signals from the two antennas into one coax for connection to the Wi-Ex Base Unit. Two 18"

coaxial jumpers are included to connect the each panel antenna to the Combiner.

YXQ21-CEL

Cellular

Panel

Antenna

(Note GREEN

CEl

label

on back)

YXQ23-PCS

PCS Panel

Antenna

(Note ORANGE label

on back)

/18"

Coax

Jumpers

Antenna /

Combiner

Mounting Mast

(Not supplied)

YXQ39-PCS-CEL

Front

View

YXQ39-PCS-CEL Rear

View

Maximum performance will be achieved when the antennas are aimed at the strongest signal from your

wireless provider. If you know the direction of your provider's tower, simply point the antenna

that

direction. Note: the closest tower may NOT be used by your provider. Some helpful hints are included if

you are unsure where your tower

located.

Installation Steps:

The highest mounting point will usually produce the best results. If you do not have roof access,

you should choose the side

the building with the strongest signal. With your wireless phone

turned

on,

walk around your house while noting the number

"bars"

your signal strength

indicator.

When you have determined the location ofthe strongest signal, attach the antennas to a mast or

pole with the brackets provided as shown

the picture above. Loosely tighten the antennas to

the mast to allow the antennas to be reoriented for strongest signal.

Connect the coax jumperfrom the YX021-CEL panel antenna to the connection on the Combiner

marked CEL.

Connect the coax jumper from the YX023-PCS panel antenna to the other Combiner port marked

PCS.

1 2 3 4 5 6

Summary of Contents

Page 1 - Installation Guide

W~·»E1-XExtendingCellZonesYX039-PCS-CELDual-BandSignal AntennaInstallation GuideThe YX039-PCS-CEL dual-band outdoor signal antenna system allows your

Page 2 - 6-8 feet from the Base Unit

5.Connect the RG-6 coax from the Base Unit to the Combiner output port, route coax to the BaseUnit indoors and connect the other end ofthe coax to the

Page 3 - Installation

1(.»...~I~-ExExtendingCellZonesYX023 SignalAntennaInstallationCongratulationsIThishigh-powered,high-gaindirectionalantennawillallowyourWirelessExtend

Page 4

5.Continue to rotate the antenna mast another 90 degrees in the same direction andrecord the phone signal bars (C).6. Again, rotate the antenna mast a

Page 5 - Extending

WCe»E1-XExtendingCellZonesYX021-CEL Signal Antenna InstallationThe YX021-CELisa high gain, directional panel antenna for use with the Wi-Ex zBoostYXSO

Page 6 - Rev. 20100511

AntennaAiming:To get the maximum benefit, you will want to take special care to make sure you point the antennainthedirectionofthe best signal for you

ZBoost YX600 Series User Manual

Browse online or download User Manual for Cellular signal boosters ZBoost YX600 Series. W~·»E

Summary of Contents

More documents for Cellular signal boosters ZBoost YX600 Series

Comments to this Manuals