ZBoost YX600 Series User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
W
Ce»E
1-
X
Extending
Cell
Zones
YX021-CEL Signal Antenna Installation
The YX021-CEL
is
a high gain, directional panel antenna for use with the Wi-Ex zBoost
YXSOO
and
YX600 Series amplifiers to provide maximum signal strength and increase the area
of
improved signal
coverage
Maximum performance will be achieved when the antenna is aimed at the strongest signal from your
wireless provider. If you know the direction
of
your provider's tower, point the flat front face
of
the
antenna
in
that direction. Note: the closest tower may NOT be used by your provider. Some helpful hints
are included ifyou are unsure where your tower is located.
Note: Unplug the Base Unit until all cables are connected. Plug-in the Base Unit and
verify that the Power light stays green and no red indicators light; otherwise, you
may have to reorient the antenna or relocate to another location
in
the room. See
the Troubleshooting section and www-wi-ex.com for more information.
Installation
Steps:
1.
The highest point will usually produce the best results. Ifyou
do
not have roof access, you
should choose the side
of
the building with the strongest signal. With your wireless phone turned
on, walk around your house while noting the number
of
"bars" on your signal strength indicator.
2.
When you have determined the location
of
the strongest signal, install and tighten the antenna to
your antenna mast or pole with the brackets provided. Loosely tighten the mast, so that you can
rotate it from the base.
3.
Place the Heat Shrink tubing over the coax and connect the RG-6 coax cable to the antenna.
4.
Wrap the F- type connector using the Coax-Seal tape provided
in
the package.
5.
Slide the Heat Shrink tubing overthe connectors and apply heat to shrink the tubing to
weatherproof the connection. A hair dryer or other heat source may be used to shrink the tubing.
6.
Route the antenna cable indoors and connect it to the base unit using the Cell Phone Signal
Booster installation instructions.
Rev.
20100511
Page view 4
1 2 3 4 5 6

Comments to this Manuals

No comments