ZBoost YX600 Series User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 6
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Antenna
Aiming:
To get the maximum benefit, you will want to take special care to make sure you point the antenna
in
the
direction
of
the best signal for your wireless service provider.
1.
Place your cell phone
on
a non-metal surface which
is
6-8 feet from the Base Unit Antenna.
2.
Turn the signal booster
on
and wait 30 seconds. Note the number
of
signal bars displayed
on
your cell phone. For best results, you want your phone to display
in
the middle
of
the signal
meter range or less so that it can go up as you rotate the Signal Antenna to the optimum
direction. If
it
is reading too high, move the phone farther from the base unit antenna.
3.
Record the number
of
signal bars (or range) (A)
on
your cell phone. Leave the phone
in
the same place and pointing
in
the same direction for the following steps.
Note the direction
of
the antenna starting
position_-:-:_-:-_----:_-:-:-
_
4.
Rotate the antenna mast 90 degrees and then record the phone signal bars (B).
5.
Continue to rotate the antenna mast another 90 degrees in the same direction and record the
phone signal bars
(C).
6.
Again, rotate the antenna mast another 90 degrees
in
the same direction and again record the
phone signal bars (D).
7.
Look for the highest reading above. Set the antenna to that position and tighten the antenna
mast.
8.
If you desire to optimize further, then look for the two highest signal bar readings above and move
the antenna between these two points to find the highest signal bars reading.
9.
Once you have determined the highest reading position tighten the antenna mast.
You have now completed the Directional Signal Antenna installation.
Troubleshooting:
~
Please consult your Wi-Ex Cell Phone Signal Booster installation guide for more complete
troubleshooting information.
For the latest
installation
tips
and
drawings,
visit our website at www.wi-ex.com and click
on
the
Installation button and the FAQ's button (Frequently Asked Questions).
Specifications:
Frequency Range
Gain
VSWR
Impedance:
Polarization
Dimension
Weight
Connector
824-896 MHz
8dBi
<1.5
75 ohms
Vertical
10.75"L x10.0"W x 2.25"H
1.551bs
Type F-female
Rev. 20100511
Page view 5
1 2 3 4 5 6

Comments to this Manuals

No comments